Kodak i600 Series Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Urządzenia wielofunkcyjne Kodak i600 Series. Kodak i600 Series User's Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj

Podsumowanie treści

Strona 2 - Contents

2-2 A-61500 April 2007 Making connections Follow the instructions for installing the IEEE-1394 (FireWire) card and the Kodak driver software before y

Strona 3

A-61500 April 2007 2-3Attaching the power cord The Kodak i600 Series Scanner is packed with a set of power cords. 1. Select the power cord which com

Strona 4 - 1 Introduction

2-4 A-61500 April 2007 7 Stop/Pause and Start/Resume buttons — 8LEDs— illuminate or flash from top to bottom as follows:Illuminates when the power is

Strona 5

A-61500 April 2007 2-5Internal componentsSeparation roller — provides smooth document feeding of various sizes and textures one document at a time.I

Strona 6 - Supporting

2-6 A-61500 April 2007 Sensors — the scanner has 3 (ultrasonic) multi-feed detection sensors, 1 (optical) paper path sensor and 1 (optical) paper pre

Strona 7 - Environmental

A-61500 April 2007 3-1 3 Using the ScannerThis chapter provides the following operational procedures:• Turning on/off the scanner• Starting, stoppin

Strona 8 - Power system

3-2 A-61500 April 2007Manually pausing and resuming the scannerWhile scanning documents:• Press the Stop/Pause button on the scanner once to pause sc

Strona 9 - 2 Getting Started

A-61500 April 2007 3-3Document preparationBefore you begin scanning documents, make certain the documents can be fed through the scanner easily.• A

Strona 10

3-4 A-61500 April 2007Maximum Document Size: 30.5 x 86 cm (12 x 34 in.). Documents larger than 43 cm (17 in.) require operator assistance.Paper inks:

Strona 11 - Scanner components Front view

A-61500 April 2007 3-5Locking the side guides Side guides may be locked into position after they are adjusted. This may be helpful when the placeme

Strona 12

A-61500 April 2007 iContents1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1Scan

Strona 13 - Pre-separation pad

3-6 A-61500 April 2007Adjusting the front of the output tray To raise the front of the output tray:1. Lift the front of the output tray.2. Swing the

Strona 14

A-61500 April 2007 3-7Adjusting the output tray for documents from 43 cm (17 in.) to 86 cm (34 in.)An output tray document extender is available for

Strona 15 - 3 Using the Scanner

3-8 A-61500 April 2007Adjusting the optional short document trayA short document tray is available for scanning smaller documents. This tray can be o

Strona 16 - button

A-61500 April 2007 3-9Feeding documents using multi-feed detectionThe scanner has three multi-feed detection sensors. When Multi-feed detection is e

Strona 17 - Document

3-10 A-61500 April 2007Manual feeding To manually feed documents:1. Position the document you want to feed in the elevator tray so that the paper pre

Strona 18 - Adjusting the side

A-61500 April 2007 3-11Calibrating the scannerThere are two types of calibration that can be performed on the i600 Series Scanners: Image calibratio

Strona 19 - Adjusting the back of

3-12 A-61500 April 2007The main Kodak Scanner window will be displayed.7. Click the Setup icon to access the main Kodak Scanner window.8. Click Setti

Strona 20 - Forward detent positions

A-61500 April 2007 3-13The following screen will be displayed.10.Click Diagnostics. The following screen will be displayed.11. Click Calibrate. 12.S

Strona 21 - 86 cm (34 in.)

3-14 A-61500 April 2007NOTE: If calibration fails, check the Operator Log for details. See Chapter 6, “Accessing the Operator Log” for more informati

Strona 22 - Adjusting the

A-61500 April 2007 4-14 The Enhanced PrinterThis chapter provides instructions for using the Enhanced Printer. The following information and procedure

Strona 23 - Feeding documents

ii A-61500 April 2007 Calibrating the scanner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-11Image calibration . .

Strona 24

4-2 A-61500 April 2007 Printer specificationsCharacteristic DescriptionMaximum lines 1 Maximum characters 40Print locations (horizontal) 12 front man

Strona 25 - Calibrating the

A-61500 April 2007 4-3Changing print positionsThe horizontal print position can be changed manually. Changing the front horizontal print position1. Re

Strona 26 - 9. Click Device

4-4 A-61500 April 2007 3. The printer carrier slides easily along the rail. There is a small arrow on the green printer carrier. Slide the printer ca

Strona 27

A-61500 April 2007 4-5Replacing the ink cartridgeReplace the ink cartridge when:• printed characters appear light or uneven• missing characters are ev

Strona 28

4-6 A-61500 April 2007 6. Press and hold the release tab on the bottom of the printer carrier and rotate the printer carrier back into position.NOTE:

Strona 29 - 4 The Enhanced Printer

A-61500 April 2007 4-7Replacing the blotter stripsBlotter strips collect ink overflow. They should be replaced when there is a build-up of ink. Replac

Strona 30 - Printer specifications

4-8 A-61500 April 2007 6. Align the blotter strip in the transport channel. Be sure it is properly aligned before pressing the adhesive side into the

Strona 31 - Changing print

A-61500 April 2007 5-1 5 MaintenanceThis chapter provides:• a cleaning frequency chart• a list of cleaning tools and materials• a list of supplies a

Strona 32

5-2 A-61500 April 2007 Cleaning frequency chartA recommended cleaning sequence includes vacuuming the scanner transport, cleaning the residue from th

Strona 33 - Replacing the ink

A-61500 April 2007 5-3Supplies and accessoriesContact your scanner supplier to order supplies. NOTE: Items and catalog numbers are subject to change

Strona 34

A-61500 April 2007 1-11 IntroductionThis User’s Guide provides information and procedures for the Kodak i600 Series Scanners. The information in thi

Strona 35 - Replacing the blotter

5-4 A-61500 April 2007 Cleaning procedure Follow the cleaning procedure below to ensure the best scanner performance and image quality.Cleaning the o

Strona 36

A-61500 April 2007 5-5Cleaning the drive rollers 5. Manually rotate and wipe the NFR and drive rollers with a roller cleaning pad.IMPORTANT: The ro

Strona 37 - 5 Maintenance

5-6 A-61500 April 2007 Cleaning the feed module tires11. Lift up the printer access cover.12.Push the release lever down (located underneath the prin

Strona 38 - Cleaning tools and

A-61500 April 2007 5-715.Reinstall the feed module by aligning the pins, fitting it into position and pulling up on the release lever to lock it int

Strona 39 - Supplies and

5-8 A-61500 April 2007 Cleaning the scanner transport area17.Thoroughly vacuum the entire transport area, paying particular attention to these areas:

Strona 40

A-61500 April 2007 5-9Cleaning the background strips18.Using the green tabs pull off the upper and lower background strips and set them aside.19.Vac

Strona 41

5-10 A-61500 April 2007 23.Carefully vacuum the areas between the lamps (both upper and lower), then use a Staticide wipe to thoroughly clean the gla

Strona 42

A-61500 April 2007 5-11Running a transport cleaning sheet1. Place a transport cleaning sheet in the elevator tray in landscape orientation.2. Open t

Strona 43

5-12 A-61500 April 2007 Replacement proceduresThis section provides procedures for replacing the following parts. Use the list below as a guideline f

Strona 44

A-61500 April 2007 5-134. Push down on the release lever (located underneath the printer access cover) to release and remove the feed module.5. If y

Strona 45 - Lower strip

1-2 A-61500 April 2007 Scanner models • Kodak i610 Scanner is a desktop duplex black and white and grayscale scanner with an automatic document feed

Strona 46

5-14 A-61500 April 2007 If you want to replace the tires, proceed as follows:6. With one hand, press the locking tabs (one on each side) while holdin

Strona 47

A-61500 April 2007 5-1512.Align the tabs on the upper housing with the slots on the lower housing.13.Press the upper and lower housings together unt

Strona 48 - Replacement

5-16 A-61500 April 2007 Replacing the separation roller or separation roller tires1. Open the pod.2. Pull the separation pad holder forward and remov

Strona 49

A-61500 April 2007 5-17Replacing the pre-separation padChange the pre-separation pad when the frequency of double-fed documents increases.1. Open th

Strona 50 - Core assembly

A-61500 April 2007 6-16 TroubleshootingThis chapter provides:• A description of the indicator lights located on the front of the scanner.• Informati

Strona 51

6-2 A-61500 April 2007 Led display DescriptionScanner is in sleep mode and has detected a hardware error. Cycle power on the scanner. If the conditio

Strona 52 - Replacing the separation

A-61500 April 2007 6-3Accessing the Operator LogThe Operator Log is accessed through the Scan Validation Tool.1. Select Start>Programs>Kodak&g

Strona 53 - Replacing the imaging

6-4 A-61500 April 2007 6. Click Settings. The following screen will be displayed.Click Device.The following screen will be displayed.

Strona 54 - 6 Troubleshooting

A-61500 April 2007 6-57. Click Diagnostics. The following screen will be displayed.8. Click the Logs tab. 9. From the drop down box, select Operator

Strona 55 - 6-2 A-61500 April 2007

6-6 A-61500 April 2007 Message listing Following is an alphabetic list of messages and corrective actions you can take if one of the following messag

Strona 56 - Operator Log

A-61500 April 2007 1-3• Automatic and manual feeding.• JPEG compression allows color and grayscale images to be viewed in most image viewers.• Image

Strona 57 - 6-4 A-61500 April 2007

A-61500 April 2007 6-7Operator Log Message ID# Description/ActionImage buffer exceeded threshold 1, 48 The feeder has stopped and the transport is s

Strona 58

6-8 A-61500 April 2007 Operator Log Message ID# Description/ActionMulti-feed detected 23 A multi-feed document condition has been detected and the sc

Strona 59 - 6-6 A-61500 April 2007

A-61500 April 2007 6-9Operator Log Message ID# Description/ActionPrint head not installed 282 An attempt was made to use the Document Printer withou

Strona 60 - A-61500 April 2007 6-7

6-10 A-61500 April 2007 Operator Log Message ID# Description/ActionUltrasonics calibration succeeded 332 Informational message. The scanner ultrasoni

Strona 61 - 6-8 A-61500 April 2007

A-61500 April 2007 6-11Numerical message listingUse the following numeric listing to quickly find an error. Use the previous Message Listing chart f

Strona 62 - A-61500 April 2007 6-9

6-12 A-61500 April 2007 ID# Description/Action297 Elevator too full, feed module missing or broken301 Image size exceeds available memory306 Close po

Strona 63 - 6-10 A-61500 April 2007

A-61500 April 2007 6-13Problem solving Use the chart below as a guide to check possible solutions to problems you may encounter when using the Kodak

Strona 64 - Numerical message

6-14 A-61500 April 2007 Problem Possible SolutionLong documents are not feeding or are jammingMake sure that:• the elevator tray extender is pulled o

Strona 65 - 6-12 A-61500 April 2007

A-61500 April 2007 A-1Appendix A AccessoriesThis chapter provides a description for the accessories that are available for use the Kodak i600 Series

Strona 66 - A-61500 April 2007 6-13

A-61500 April 2007 B-1Appendix B SpecificationsScanner Type/Speed• i610 Scanner: duplex bi-tonal and grayscale scanner with an automatic document fe

Strona 67 - 6-14 A-61500 April 2007

1-4 A-61500 April 2007 Safety information Warning labelsMSDS Material Safety Data Sheets (MSDS) are available on the Kodak website at: www.kodak.com/

Strona 69 - Appendix B Specifications

A-61500 April 2007 1-5EMC statementsUnited States This equipment has been tested and found to comply with the limits for a Class A digital device pu

Strona 70

A-61500 April 2007 2-12 Getting StartedSite specifications Place the scanner:• In a clean area with temperature and relative humidity typical of an

Komentarze do niniejszej Instrukcji

Brak uwag